Main Roads WA Heavy Vehicle Services (HVS) has published several updates since the August mass and dimension changes. Two are most relevant if you move wide loads around Perth or run vehicles under the Heavy Vehicle Mass Management Scheme (HMMS). Two older notices are worth a second look too.
1. Tonkin Highway, Roe Highway to Kelvin Road: width constraints coming
In HVS Update 24-2026 (15 September 2026), Main Roads says it expects width restrictions on Tonkin Highway between Roe Highway and Kelvin Road once construction begins as part of the highway upgrade. The notice is scheduled to stay published until 31 December 2026.
- Concrete barriers are expected to be installed in December 2026 as the upgrade progresses.
- Oversize loads wider than 5.9 metres must keep at least 1.2 metres of ground clearance to pass the barriers safely.
- Operators are asked to watch for changes to traffic management throughout the works and to carry out regular route surveys to confirm their access remains safe and compliant.
If a wide load of yours uses this corridor, check the route now rather than the week of the move. Dates in the notice are expected dates, so confirm the current position with Main Roads.
2. HMMS Business Rules updated
In HVS Update 25-2026 (22 October 2026), Main Roads says it has updated the HMMS Business Rules following the August 2026 changes to the mass and dimension limits. Two points from the notice:
- The requirement relating to statutory mass weights has been removed.
- The general mass requirements and tolerances that apply are now set out in the Business Rules.
Main Roads asks operators to use the updated Business Rules to work out the mass requirements for vehicles operating under the HMMS. If that is you, read the current document rather than relying on an older copy.
Two earlier notices worth a second look
These were each published for one month, so they may no longer be on the Main Roads updates page. Check the current position before you plan around them.
- Tonkin Highway contraflow (HVS Update 22-2026, 11 August 2026). After heavy vehicle pilot industry representatives raised safety concerns, Main Roads revised the traffic guidance scheme for the contraflow between Hale Road and the Abernethy Loop Ramp. The minimum number of pilots needed to run the movement has increased. The full requirements are in TGS OSOM 2026-05 on the Main Roads website.
- Great Northern Highway guardrail, Pilbara (HVS Update 23-2026, 21 August 2026). New guardrail has been installed on a realigned section between Newman and Juna Downs (SLK 1259.42 to 1262.23). Main Roads describes about 12 metres of horizontal clearance and barriers roughly 1.0 metre high, and says some OSOM loads may be affected when passing oncoming heavy vehicles. Operators are urged to allow for the reduced operating envelope in their route surveys.
What to do with this
- When you ask for a quote on a wide or heavy move, tell the transport company which roads the load needs to use.
- Ask when the route was last surveyed, and by whom.
- Build a little extra time into any move through a corridor with works under way.
Sources
- Main Roads WA, HVS Update 24-2026: Oversize Load Constraints During Tonkin Hwy Upgrades (15 September 2026)
- Main Roads WA, HVS Update 25-2026: HMMS Business Rules Update (22 October 2026)
- Main Roads WA, HVS Update 22-2026: Revised Tonkin Highway Contraflow Traffic Guidance Scheme (11 August 2026)
- Main Roads WA, HVS Update 23-2026: New Guardrail Barriers on Great Northern Highway, Pilbara (21 August 2026)